Ezflora small problem

Comments and suggestions on the EZFlora irrigation controller

Moderator: Justin

Posts: 1
Joined: Fri Jun 17, 2011 1:03 pm

Ezflora small problem

Postby ceaser2000 » Tue Jun 21, 2011 6:20 pm

I have a Ezflora that I am using with insteon smartlinc. I used the direct command method so I can control each valve seperatly. All is working ok except in mobilinc and the insteon smartlinc page all my valve status show as "on" all the time. I can hit on for a particular valve and it goes on, aswell I hit off and the valve goes off, just always shows as on. I checked my direct code entries, and tried reset but no change. Any help or experience with this would be much appriecated.

Return to “EZFlora”

Who is online

Users browsing this forum: No registered users and 1 guest