Page 1 of 1

Command keeps getting sent

Posted: Sat Jun 29, 2013 11:04 pm
by ccallana
Ok, so from my other thread, I figured out how to write a proper wizard :) Now I have a new problem.

Not every time - after a wizard fires, it keeps sending the same command over and over for hours.

For instance I have one right now

Within 8pm +- 15 minutes, every day, next on 29 Jun 2013 (this seems odd in itself, it should have already fired and have the next as 30 Jun)
Turn on lights

well, since this wizard was triggered, I have a command repeating on the line to turn on that light. The light on the side of the Harmony is blinking, and I can see it on my XTBM. It should have just fired once and been done.

Re: Command keeps getting sent

Posted: Mon Jul 01, 2013 6:01 pm
by Dhawal
Can you take a picture of this wizard and email it to me please. Thanks.

Re: Command keeps getting sent

Posted: Mon Sep 09, 2013 12:35 am
by Dhawal
This bug has been fixed with Harmony Gateway firmware 1.09 and above.